How to Install a Lock Washer
- 1). Measure the specific application to be worked upon as accurately as possible. Determine if there's room enough for a lock washer and if the added thickness of a lock washer impedes any mechanical action. Decide if a free-spinning lock washer (most common available) will fully meet your needs. There are two types of free-spinning lock washers to choose from. Lock spring washers are the simplest in design (they look like a broken washer) and are what most people call a "lock washer." They also provide the least protection against loosening. Internal lock washers look like a regular washer, with many small ridges on one side and provide a stronger hold than lock spring washers.
- 2). Verify the pitch and thread count of the bolt in your application. This is easily accomplished by matching the nut or bolt with one of the same size either at the hardware store, or from a known source in your home. Decide if a more complex type of lock washer, such as a free spinning lock washer or a locking nut, will work better in your application. Free-spinning lock washers are washers that are embedded in the base of a nut. They create friction when turned in the "loosening" direction. Lock nuts are nuts that use the body of the nut itself as the washer, with a substance (metal or plastic) embedded within the nut's threads that provide extra friction to eliminate loosening. In either case, an exact match must be found between the old nut and the new complex lock washer/nut assembly in order for it to work properly.
- 3). Measure the shank width of the bolt upon which you desire a tight connection. The lock washer should be sized so that there is very little room to move when placed on the shank of the bolt. Lock washers are always placed directly adjacent to the nut of the application. So if using a lock spring washer or an internal lock washer, place it over the shank of the bolt just prior to the nut attachment.
- 4). Measure the thread size of the bolt if you are going to use a free spinning lock washer or a locking nut. It is important that these are sized with the exact same threads (sae or metric) so that the nut will tighten and hold as designed. An improper thread size will eliminate the advantage of using this type device.
- 5). Torque the nut until it is tight using a wrench or, if available, a torque wrench set to the desired torque setting of the application.